Fibre Channel LogiCORE IP Offerings and System Requirements
| The following configurations are included
with the Xilinx Fibre Channel IP Core (EF-DI-FC). . |
|||
| System Requirements | |||
| LogiCORE | Software Requirements | Required Patches |
Supported Devices and Speed Grades |
| Fibre Channel v3.4 (Point to Point) | |||
| 1 Gbps operation |
|
Check the Master IP Release Note Guide for information on any required patches. |
Virtex®-5, LXT, SXT (-2) Virtex-4, FX (-10) * Virtex-II Pro (-5) ** |
2 Gbps or dual 1G/2G operation |
|
Check the Master IP Release Note Guide for information on any required patches. |
Virtex-5, LXT, SXT (-2) Virtex-4, FX (-10) * Virtex-II Pro (-6) ** |
| 4 Gbps or dual 2G/4G operation |
|
Check the Master IP Release Note Guide for information on any required patches. |
Virtex-4 FX (-11)* |
* Virtex-4 FX: 4VFX20 or larger
** Virtex-II Pro: 2VP20 or larger
Hardware Evaluation Time Out Period
A Hardware Evaluation license for the LogiCORE™ IP Fibre Channel Pt. to Pt. core will enable you to parameterize, generate and instantiate this cores in your design. You will also be able to perform functional and timing simulation and generate a bitstream that you can use to download and configure your design in hardware.
The IP cores will be fully functional in the programmed device for approximately 8 hours. After this time, the IP will "time out" (cease to function) and you will need to download and configure the FPGA again