|
Xilinx allows you to perform Full System Hardware Evaluation
of the LogiCORE™ H.264 CABAC IP core.
- .Full System Hardware Evaluation
allows you to do everything you can do with the Fully Licensed
IP core, including configure place and route, simulate, estimate
timing, and program a Xilinx FPGA device. For
this core, the device programmed with the Hardware Evaluation
version of the core will cease to operate after 8 hours. The core
can be reactivated by re-programming the device.
| Requirements |
|
Install these updates if you have not already done so:
| Updates |
Installation Instructions and
Release Notes |
ISE 9.1i SP1 (9.1.01i) or later |
- Install the required ISE Service Pack in one of
the following ways:
- Run WebUpdate from the ISE Project Navigator
Help menu, OR
- Download the indicated updates from the
Xilinx Download
Center and run the standalone installer included
in the zip file.
- Review the Critical Information
link for the Service Pack on Download
Center for Installation instructions and
Release Note information on What's New, Bugs
Fixed and Known Issues.
|
(NOTE: You must be registered on Xilinx.com to access
these updates.)
|
| Download
and Install the Evaluation Core |
| Full
System Hardware Evaluation Files |
|
To perform a Full System Hardware Evaluation:
- Make sure you have satisfied the requirements.
- Download (requires Xilinx login):
- Refer to the User Guide for information on installing
and using these evaluation components.
| Note that the core will cease to function in the programmed
device after 8 hours. |
|
| Release
Notes, Known Issues & Support |
|
Release Notes and Known Issues are documented in AR
25254.
For support on this evaluation, please contact your Xilinx
FAE.
|
|
 |
|
