Instructions
The links below will assist you during the installation process. The links should be used in conjunction with the installation instructions.
Step 1: Register ML300
- You must register your ML300 Evaluation Platform to obtain your software registration IDs and access information about the ML300. Register before proceeding any further.
Step 2: Register CoreConnect (Optional)
CoreConnect™ is an IBM-developed on-chip bus-communications link that enables chip cores from multiple sources to be interconnected to create entire new chips. It is recommended to register for CoreConnect to achieve the fullest design experience with your ML300 Evaluation Platform.
Step 3: Download ML300 Reference Design, ISE/ EDK Service Packs, and ChipScope Pro Software
Various downloads are required during the installation of the ML300 Evaluation Platform. The following links will assist you in obtaining all the required downloads.
- Get ML300 Reference Design from ML300 Lounge.
The ML300 Reference Design has been tested with EDK 6.2i/ISE 6.2i (without service packs) and ModelSim 5.7b. The reference design is untested against later versions of Modelsim or with any EDK/ISE service packs installed. The following service pack links are provided for reference only:
- Get ChipScope Pro.
Your ML300 purchase includes a full ChipScope Pro license. The Registration ID you received when registering ML300 will work with ChipScope Pro. Therefore, on the ChipScope Pro page proceed directly to the Download section (section #4) and download the appropriate version of ChipScope Pro.