We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 15070

8.1i XPower - XPower is unable to use an NCSIM VCD file unless buses are flattened


When I use the "vcdaddscope" command in NCSIM to add signals to the VCD file, XPower will not accept the file.


If you create a VCD file using the NCSIM "vcdaddscope" command, you must use the "-f" switch to flatten buses (vectors).

AR# 15070
Date Created 09/03/2007
Last Updated 05/20/2014
Status Archive
Type General Article