6.1i PACE/NGDBuild - Assign Pins in PACE with HDL and NGDBuild reports a port-mismatch error

AR#	17496	Search For Another Answer
Topic	SW-Floorplanner/PACE
Last Updated	03/27/2007
Status	Archive

Description

Keywords: mismatch, NGDBuild, PACE, pin

Urgency: Standard

General Description:
When I place pins in PACE, NGDBuild reports an error involving port mismatches.

Solution

This problem occurs because PACE is writing out the incorrect bus delimiters in the UCF.

You can work around this issue by loading the NGD from the design; this will correct the bus notation mismatch.

This should be fixed in the next major release of the software (after 6.1i).