UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 19106

6.2 EDK - UltraController 6.1i -> 6.2i Up-rev procedure

Description

Keywords: UltraController, EDK, rev-up, up-rev, uprev, revup, 6.1i, 6.2i, MPD, ERROR:MDT, uc_gpio_ref_v2_1_0.mpd

Urgency: Standard

General Description:
After opening a 6.1i or earlier version of the UltraController design in EDK 6.2i, I receive the following error message:

"ERROR:MDT - <UltraController
directory>\pcores\uc_gpio_ref_v1_00_a\data\uc_gpio_ref_v2_1_0.mpd:25 -
No BUS_INTERFACE OUT_PORT found as specified for PARAMETER C_PORT_DWIDTH
ERROR:MDT - Errors while parsing MPD file <UltraController
directory>\pcores\uc_gpio_ref_v1_00_a\data\uc_gpio_ref_v2_1_0.mpd"

This problem affects only users who attempt to up-rev a 6.1i or before version of the UltraController to EDK 6.2i.

Solution

The MPD file:

<UltraController directory>\pcores\uc_gpio_ref_v1_00_a\data\uc_gpio_ref_v2_1_0.mpd

must be edited to remove the "OUT_PORT:" from this line:

PARAMETER C_PORT_DWIDTH = 32, DT=integer, BUS=OUT_PORT:BRAM_PORT

After editing, the line should look like this:

PARAMETER C_PORT_DWIDTH = 32, DT=integer, BUS=BRAM_PORT

This problem will be fixed in 6.2i version of UltraController.
AR# 19106
Date Created 03/05/2004
Last Updated 03/08/2006
Status Archive
Type General Article