UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 22680

8.1i Schematic - Changing the sheet size in Schematic Editor has no effect

Description

Keywords: ECS, schematic, sheet, size, resize, Project Navigator, ISE, display, boundaries, increase, decrease

Changing the size of the sheet for a schematic has no effect in the Schematic Editor. The size of the sheet remains the same.

If the sheet size was decreased, you might receive the following error message when placing components near the displayed bottom or right schematic sheet border.

"Error: Command failed since it causes figures to be placed outside sheet."

Solution

The schematic sheet size has actually been changed but is not being displayed. To see the schematic with the correct sheet size, save and close the schematic, then reopen the schematic. The sheet size change should take effect.

This issue will be fixed in ISE 8.2i.
AR# 22680
Date Created 09/04/2007
Last Updated 03/05/2008
Status Archive
Type General Article