We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 23530

8.2i ISE - Project Navigator reruns Xplorer script unnecessarily after re-opening a project


Keywords: translate, MAP, PAR, status, complete, up to date, report, configuration, bit, run, implement

After implementing my design in Xplorer mode, the project is closed and re-opened. The implementation processes are correctly shown as up-to-date (green check mark). However, when I select the Generate Programming File process, or any of the reports or views based on the implementation results, the Xplorer script starts again.


The Xplorer script should not be rerun since the processes needed to start the Generate Programing File process are all up to date. In order to run the process, change Xplorer mode to Off and then run the desired process.

This problem has been fixed in the latest 8.2i Service Pack available at:
The first service pack containing the fix is 8.2i Service Pack 2.
AR# 23530
Date Created 09/04/2007
Last Updated 04/16/2009
Status Archive
Type General Article