Main
Home  :  Support  :  Answers  :  9.1.02 System Generator for DSP - When I try to simulate using Network based Ethernet co-sim with the ML506 board, I receive an error when it tries to reconnect after device configuration or if I use a 10 Mbit link speed

9.1.02 System Generator for DSP - When I try to simulate using Network based Ethernet co-sim with the ML506 board, I receive an error when it tries to reconnect after device configuration or if I use a 10 Mbit link speed

AR# 24868

Search For Another Answer
Topic SW-SysGen
Last Updated 04/18/2008
Status Active
Description

Keywords: SysGen, ethernet co-simulation, ML506

When I try to simulate using Network based Ethernet co-sim with the ML506 board, I receive an error when it tries to reconnect after device configuration or if I use a 10 Mbit link speed.


Solution

This is caused by some known issues with ISE 9.1.02i.

This has been fixed in ISE 9.1 service pack 3.
 
 
/csi/footer.htm