When running XMD in 9.1i EDK, I cannot set a watchpoint write break using the correct set of commands; break is not set as shown below:
"XMD% watch w 0x27000000
Breakpoint/Watchpoint NOT Set
Info:Processor started. Type "stop" to stop processor
RUNNING> XMD% exit"
When is this problem going to be fixed, and is there a work-around?
To work around this issue, set the watchpoints from the GDB interface.
This problem has been fixed in the latest EDK 9.1i Service Pack, available at:
The first service pack containing the fix is EDK 9.1i Service Pack 1.