AR #29165 - LogiCORE OBSAI v1.1 - Release Notes and Known Issues for 9.2i IP Update 1 (9.2i_IP1)
LogiCORE OBSAI v1.1 - Release Notes and Known Issues for 9.2i IP Update 1 (9.2i_IP1)
| AR# | 29165 |
| Part | IP-Wireless-OBSAI |
| Last Modified | 2007-09-17 00:00:00.0 |
| Status | Active |
| Keywords | CORE Generator, #1, open, basestation, architecture, initiative, Virtex-5, Virtex5, v5 |
Description
Keywords: CORE Generator, #1, open, basestation, architecture, initiative, Virtex-5, Virtex5, v5
This Release Note is for the Open Basestation Architecture Initiative (OBSAI) v1.1 released in 9.2i IP Update 1, and contains the following information:
- New Features
- Bug Fixes
- General Information
- Known Issues
For installation instructions and design tools requirements, see (Xilinx Answer 25222).
Patch is required to address critical known issues (Xilinx Answer 29194).
Solution
New Features in v1.1Supports ISE 9.2i
Bug Fixes in v1. 1
None.
General Information
None.
Known Issues in v1.1
(Xilinx Answer 29166) When simulating, warnings and errors might occur
(Xilinx Answer 29167) GTP attribute change is needed
Known Issues fixed in v1.1 Patch1
- When RP3_01 is enabled, the FCB generated at the slave has the bit order reversed.
Known Issues fixed in v1.1 Patch2
- When the length of the frame counter is greater than the 16-bit Delta counter, the core does not respond correctly to negative Delta values.
- Width mismatch in "dlink_rx_sync_fsm_if.vhd" causes a synthesis warning in XST.
- FCB counter stops half a cycle too early. This causes a small error at the time the FCB is regenerated.
To obtain a patch (either patch #1 and #2), please see (Xilinx Answer 29194).