We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 30598

Project Navigator - Status might not be updated correctly after a process has been forced to "Up to Date"


After a process is forced to"Up to Date" (Process -> Force Process Up-to-Date), changing a process property might not make the status of the process out-of-date.


In general, any time a process property is changed, the status of the project should either indicate that the process has not been run or that the process is out-of-date. When you use the Force Status option, it is possible to create a situation where this does not happen if the process property is changed back to the original value that it had during the last run.


  1. Process1 is completed while PropertyA=10.
  2. PropertyA is changed to 8 and the process goes out-of-date.
  3. Process1 is forced Up-to-Date.
  4. PropertyA is changed back to 10. Now the process does not go out-of-date since the current value is identical to the value of PropertyA when Process1 was last run successfully.

NOTE: Force Process Up-to-Date is available in Project Navigator 10.1 and later.

AR# 30598
Date Created 03/21/2008
Last Updated 05/19/2012
Status Archive
Type Known Issues
  • ISE - 10.1
  • ISE Design Suite - 11.1
  • ISE Design Suite - 12.1
  • ISE Design Suite - 13.1