^
Advanced Search

AR# 33585 11.3 iMPACT - "Indirect Programming SPI/BPI - '0': Programming terminated. DONE did not go high."

Description

Keywords: JTAG, flash, usb, configuration, fail

When I use indirect SPI or BPI programming to configure my flash, and subsequently load the FPGA, the following messages occur in the console multiple times:

"INFO:iMPACT - '0': Checking done pin....done.
'0': Programming terminated. DONE did not go high."

"Program Failed" will be displayed in the Boundary Scan window. What is the issue here?

Solution

This issue is related to post-configuration device checks that need more time to complete than is currently allowed. Pulsing PROG causes the FPGA to be programmed correctly. This issue is scheduled to be resolved in iMPACT 11.4.

Actions

AR# 33585
Date Created 09/29/2009
Last Updated 09/29/2009
Status Active
Type
Feed Back