11.4 PlanAhead - Can I change the width of my I/O Buses in Initial Pin Planning mode?

AR#	33801	Search For Another Answer
Topic	SW-PlanAhead
Last Updated	11/13/2009
Status	Active

Description

Keywords: ucf, csv port

I am doing initial pin planning on a set of ports that I have imported from either csv or ucf. I would like to change the width of some buses defined in those input files after they have been imported into PlanAhead. Is this possible?

Solution

At this time, it is not possible to change the width within PlanAhead. This functionality will be added in a future PlanAhead release.