We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 36120

MIG v3.4-v3.7 Virtex6 QDRII+ - Why are there two sets of signals on the client interface?


There two sets of signals on the client interface that end in 0 or 1. What are they for?


To accommodate burst length 2 devices, the client interface contains ports for two read and two write transactions. When using burst length 4, only the ports ending in 0 should be used. However, MIG only supports BL=4, so you must only use the ports ending in 0.
AR# 36120
Date Created 06/08/2011
Last Updated 12/15/2012
Status Active
Type General Article
  • Virtex-6 HXT
  • Virtex-6 LX
  • Virtex-6 LXT
  • Virtex-6 SXT
  • MIG