UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 41577

Planahead - How do I set a Pblock to be only used by one module?

Description

In PlanAhead, how can I set a Pblock to be used by one module only?

Solution

You can do this by following the steps below:
 
1. Open netlist design.
2. Select the pblock with assigned module.
3. In pblock properties, click "add pre-defined attributes..."
4. Add Group - > Place attribute.
5. Set Group = close; Place = close
AR# 41577
Date Created 03/31/2011
Last Updated 01/30/2015
Status Active
Type General Article
Tools
  • PlanAhead