Note: This followingissue is only seen inv1.3 of the TRD with AXI protocol support, released with ISE version 13.2. The version of makefile released with 13.1 or previous releases and those released with later versions will not see this issue.
Issue
The Application GUI does not load because the makefile to compile the GUI hasspaces instead of tabs.
Workaround
1. Open theMakefile in v6_pcie_10Gdma_ddr3_xaui_axi/linux_driver/xpmon directory in any text editor.
2. At the start of Line 11, Line 14 and Line 17, delete the spaces (represented below by "..") and introduce atab (represented below by ">") as shown below.
Line 11 as in the makefile released with 13.2:
. . $(CC) -o xpmon $(CFLAGS) $(GUI_OBJS) $(LFLAGS)
Line 11 after workaround (spaces replaced bytab):
>$(CC) -o xpmon $(CFLAGS) $(GUI_OBJS) $(LFLAGS) --
Line 14 as in the makefile released with 13.2:
. . $(CC) -c $(CFLAGS) -I ../include/ ConfigGui.c -o xpmon.o
Line 14 after workaround (spaces replaced bytab):
> $(CC) -c $(CFLAGS) -I ../include/ ConfigGui.c -o xpmon.o
Line 17as in the makefile released with 13.2:
. . rm -f $(GUI_OBJS) xpmon *.exe *.out
Line 17 after workaround (spaces replaced bytab):
> rm -f $(GUI_OBJS) xpmon *.exe *.out
| Answer Number | Answer Title | Version Found | Version Resolved |
|---|---|---|---|
| 34432 | Virtex-6 FPGA Connectivity Kit and Targeted Reference Design (TRD) - Release Notes and Known Issues | N/A | N/A |
| Answer Number | Answer Title | Version Found | Version Resolved |
|---|---|---|---|
| 34432 | Virtex-6 FPGA Connectivity Kit and Targeted Reference Design (TRD) - Release Notes and Known Issues | N/A | N/A |