UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 45932

CORE Generator - How to Re-generate an IP Core with a new target device in batch mode?

Description

I would like to change the target device of an IP Core that has previously been generated. In the CORE Generator GUI I can do this by changing the target device of the project and selecting regenerate under current project settings.

How can I regenerate the core by changing the device setting in command line or batch mode?

Solution

A Core can be re-generated by using the following command :

coregen -b xx.xco -p corgen.cgp

In order re-generate the core in command line or batch mode by changing the device setting, use the following steps:

1. Change the device setting details in the xx.xco file
2. Change the device setting details in thecoregen.cgpfile
3. Once the above change are made and saved, run the following command:

coregen -b xx.xco -p coregen.cgp

Note: Before doing this make sure the Core used is supported for the devices which you want to target.
AR# 45932
Date Created 01/23/2012
Last Updated 12/15/2012
Status Active
Type General Article
Tools
  • ISE Design Suite - 12.1
  • ISE Design Suite - 12.2
  • ISE Design Suite - 12.3
  • More
  • ISE Design Suite - 12.4
  • ISE Design Suite - 13
  • ISE Design Suite - 13.1
  • ISE Design Suite - 13.2
  • ISE Design Suite - 13.3
  • ISE Design Suite - 13.4
  • Less