AR# 50875 Zynq-7000 SoC ZC702 Evaluation Kit - Why does my board not have the SW16 switch as shown in the User Guide?
Description
UG926, Zynq-7000 All ProgrammableSoCZC702 Evaluation Kit Getting Started Guide, lists SW16 as the five-position DIP switch used to set the configuration mode.
My ZC702 does not show this SW16 - why is that?
Solution
SW16 (light blue / grey 5-position DIP switch) is present on Rev D and later revisions of ZC702, as shown below:
50875-1.jpg
Earlier revisions of the ZC702 Evaluation Kit, such as Rev B or Rev C, do not have this DIP switch present.
Instead, the mode is set using the jumpers immediately below the FMC headers as shown below:
50875-2.jpg
These are jumpers J20, J21, J22, J25 and J26.
The jumpers correspond to the settings in SW16 as follows:
50875-3.jpg
Linked Answer Records
Master Answer Records
| Answer Number | Answer Title | Version Found | Version Resolved |
|---|---|---|---|
| 47864 | Zynq-7000 AP SoC ZC702 Evaluation Kit - Known Issues and Release Notes Master Answer Record | N/A | N/A |
Actions
Feed Back