^

AR# 52143 14.x Zynq-7000 SoC AP Impact - QSPI programming on the ZC702 (7020 rev1.0 silicon) requires the board to be in QSPI mode

This is related to a Zynq-7000 errata. For reliable 14.3 Impact QSPI programming with 7020 (1.0 silicon), set the mode to QSPI boot.

To work around this issue, set the mode pins to QSPI.

Master Answer Records

Answer Number	Answer Title	Version Found	Version Resolved
47890	14.x iMPACT - Known Issues for the iMPACT 14.x tools	N/A	N/A
52538	Zynq-7000 AP SoC - Boot and Configuration	N/A	N/A
47864	Zynq-7000 AP SoC ZC702 Evaluation Kit - Known Issues and Release Notes Master Answer Record	N/A	N/A

Associated Answer Records

Answer Number	Answer Title	Version Found	Version Resolved
47596	Zynq-7000 AP SoC, Boot - Quad-SPI controller, in non-Quad-SPI boot mode, does not drive HOLD_B inactive during SPI data phase	N/A	N/A

Actions

AR# 52143
Date Created	11/20/2012
Last Updated	01/25/2013
Status	Active
Type	Known Issues
Devices	Zynq-7000
Tools	EDK - 14.3 EDK - 14.4 ISE Design Suite - 14
Boards & Kits	Zynq-7000 All Programmable SoC Boards and Kits

Feed Back