We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 57470

VC709 Connectivity TRD, 2013.2 - During XT Connectivity TRD setup, device might not be recognized


If running the VC709 Connectivity Targeted Reference Design, the TRD setup window / GUI should report the correct device is detected. You should see: "Xilinx Corporation Device 7083".


The GUI should look similar to the following:

Instead, you might see the following message: "No Xilinx Device found with Device ID 7083".

Using the lspci command in the fedora terminal will read the Xilinx board as "Xilinx Corporation Device 7038", which is incorrect.

The message "No Xilinx Device found with Device ID 7083" is usually seen if the TRD is not loaded onto the board.

The Virtex-7 FPGA VC709 Connectivity TRD should arrive with the Connectivity TRD pre-loaded. However, if this is not the case, or a customer has re-programmed the flash, the above message might appear. If that is the case, you will have to program the BPI flash on the VC709 with the Targeted Reference Design before getting started with the TRD.

For more details, see the "Programming the VC709 Board" section of UG962 for instructions on programming the BPI on board with the programming script:

NOTE: For VC709 TRD 2013.2 Known Issues, see (Xilinx Answer 58082) - Virtex-7 FPGA VC709 Connectivity Kit - TRD Release Notes.

Linked Answer Records

Master Answer Records

Answer Number Answer Title Version Found Version Resolved
58082 Virtex-7 FPGA VC709 Connectivity Kit - TRD Release Notes N/A N/A
AR# 57470
Date Created 09/16/2013
Last Updated 11/07/2013
Status Active
Type General Article
  • Virtex-7
Boards & Kits
  • Virtex-7 FPGA VC709 Connectivity Kit