UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 58406

2013.2 Hardware Manager - ERROR:[Labtools 27-1974] Mismatch between the design programmed into the device XC7K325T_​0 and the probes file

Description

The following error appears when programming a device in Hardware Manager:

 

ERROR:[Labtools 27-1974] Mismatch between the design programmed into the device XC7K325T_0 and the probes file xxxx/impl_1/debug_nets.ltx.
The device design has 0 ILA core(s) and 0 VIO core(s). The probes file has 1 ILA coe(s) and 0 VIO core(s).
Resolution: Make sure the device probes file is up-to-date, then re-program the device.

 


 


What is the cause of this error?

Solution

This following are possible fixes for this error:

 

  • Ensure that the .bit file and the .ltx file assigned to this device match each other.

  • Ensure that the capture clock to the ILA is a free running clock

  • Ensure that timing requirement has been met after inserting Debug cores.

  • The error can be caused by a Signal Integrity issue on the board.
    A case was found where the issue was caused by a bad USB Cable.

  • In one case creating a new project resolved the error.

  • Ensure that the Version of the core matches the version of the tools, and hw_manager.

 

AR# 58406
Date Created 11/15/2013
Last Updated 08/19/2016
Status Active
Type General Article
Tools
  • Vivado Design Suite - 2013.2