UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 58644

LogiCORE IP Digital Pre-Distortion (DPD) v6.0 - The requirement of having the DCL state machine reset before starting the DCL process after boot up

Description

The DCL state machine has no defined default state which may cause a poor initial update. The poor update can prevent the DPD core from achieving good correction performance.

Note: This applies to all versions of the DPD core.

Solution

Send either the SET_DCL_PARAMETERS or RESET_DCL commands before issuing any of the RUN_DCL commands (RUN_DCL, RUN_DCL_WITH_ACCEL_QMC, or RUN_DCL_WITH_QMC). Either of these commands will reset to the state machine within the DCL routine.

For a detailed list of Digital Pre-Distortion (DPD) Release Notes and Known Issues, see (Xilinx Answer 33251)

AR# 58644
Date Created 12/03/2013
Last Updated 12/13/2013
Status Active
Type General Article
IP
  • Digital Pre-Distortion (DPD)