We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 61247

U-boot - Command "saveenv" may corrupt boot image.


When the "saveenv" command is run in u-boot, the zynq board cannot boot again.

This is because the command has saved environment data to the boot image.


The below definition can be found in the u-boot source file /include/configs/zynq-common.h
define CONFIG_ENV_OFFSET 0xE0000
To resolve this issue change the address to higher than boot image length.
AR# 61247
Date Created 06/24/2014
Last Updated 06/25/2014
Status Active
Type General Article
  • Zynq-7000