We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 61356

MIG 7 Series - Artix-7 CSG235 only contains HR banks but the MIG Bank Selection page shows Bank 34 as HP


Version Found: MIG 7 Series v2.1
Version Resolved: See (Xilinx Answer 54025)

In accordance with UG475 Artix-7 CSG235 parts do not contain HP banks but the MIG Bank Selection page shows Bank 34 as HP.

MIG uses DCI I/O standards by default for HP banks which results in incorrect XDC constraints when targeting Bank 34.


This is a known issue and can be worked around by deselecting HP Bank 34 and selecting one of the HR Banks in the left column.

If Bank 34 is required then the I/O Constraints must be manually modified in the XDC.

Note: Until this issue is fixed only 8-bit wide interfaces can be generated.

Please open a webcase with Xilinx Technical support if assistance is needed.

Revision History

07/15/2014 - Initial Release

Linked Answer Records

Master Answer Records

Answer Number Answer Title Version Found Version Resolved
54025 MIG 7 Series - IP Release Notes and Known Issues for Vivado 2013.1 and newer tool versions N/A N/A
AR# 61356
Date Created 07/02/2014
Last Updated 07/15/2014
Status Active
Type Known Issues
  • Artix-7
  • Vivado Design Suite - 2014.2
  • MIG 7 Series