We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 63572

Vivado 2014.4 - IBERT - Data push/pull persistance for project and non project mode


How are the GT settings pushed and pulled when opening an IBERT project?

Do these settings persist for a giving bitfile/project?


If a project is opened, immediately after download, the settings are read.

Then they are checked against the project, and the project settings are pushed to the device.

After that, the GUI will always reflect what is in the device due to periodic polling.

In non project mode, the bitfile will load, but no pre-saved settings will be loaded.
Instead it will use the default settings.
AR# 63572
Date Created 02/13/2015
Last Updated 04/07/2015
Status Active
Type General Article
  • FPGA Device Families