We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 64234

High Speed SelectIO Wizard - Unable to select strobe/capture clock I/O Location when switching to the RX TX Bidirectional interface type


I am using the High Speed SelectIO Wizard.

I select an RX TX Separate Interface Type then change this to the RX TX Bidirectional Interface Type.

On the Interface Pin Assignment Tab, the Interface IF Strobe Pin LOC menu is missing.

How can I work around this?


You can work around this issue by selecting 0 in the Number of Strobes on the Interface Settings tab and then selecting the required number again. 

Please refer to (Xilinx Answer 64216) High Speed SelectIO - Known Issue List for the software version that the issue is resolved in.

Linked Answer Records

Master Answer Records

Answer Number Answer Title Version Found Version Resolved
64216 High Speed SelectIO Wizard - Known Issue list N/A N/A
AR# 64234
Date Created 04/13/2015
Last Updated 05/14/2015
Status Active
Type General Article
  • Kintex UltraScale
  • Virtex UltraScale