UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 7120

*Obsolete* Hardware Debugger M1/M2 - "Error: XChecker cannot bring D/P low to reconfigure the device. Reset the Target board to continue."

Description

Keywords: configuration, hardware, debugger, xchecker

Urgency: Standard

General Description:
When I try to configure an FPGA via the Hardware Debugger and XChecker or Parallel cable, the following error occurs:

"XChecker cannot bring D/P low to reconfigure the device. Reset the Target board to continue."


Solution

Ensure that VCC and GND are connected on the cable to the board. The pod on the cable is powered via these connections.
AR# 7120
Date Created 08/31/2007
Last Updated 09/26/2005
Status Archive
Type ??????