Configure JTAG Settings dialog box

In the Configure JTAG Settings dialog box, specify the JTAG cable to use for communication and the JTAG Device Chain information for the board. To open the Configure JTAG Settings dialog box, select Tools > Configure JTAG Settings.

The Configure JTAG Settings dialog box contains the following functions.

Name	Function
JTAG Cable	Specify the JTAG Cable settings
Type	Specify the Cable type. The default is "auto"
Port	Specify the port on the host machine where the cable is connected
Frequency	Specify the frequency to run the cable
JTAG Device Chain	Specify the JTAG Device chain information for the board
Auto-Discover Devices	Use this option for SDK to automatically detect the devices in the chain. This is recommended for most users
Maunal Configuration	Use this option if the auto-discover failed
Use	Specify the FPGA device for communication by SDK
No	The device number in the chain
Device Name	Name of the Device
ID Code	The JTAG ID code of the device
IR Length	The JTAG IR Length of the device
Add/Delete/Move Up/Down	Use these options to specify the devices in the chain

JTAG settings
Embedded hardware components
Programming parallel Flash

Configure the JTAG settings
Program FPGA
Programming parallel Flash memory
Debugging