Programming parallel Flash memory

To program the parallel Flash memory:

Select Tools > Program Flash Memory.
In the Select Processor dialog box that opens, select the processor instance to which the parallel Flash memory is connected.
In the File to Program field, specify the executable file, bitstream, or data file to write to Flash.
If you are programming an executable file (in ELF format) and would like to use a bootloader to boot the processor after reset, click to select the Automatically convert file to bootable SREC format when programming Flash check box.
Select the Flash memory using the Instance Name drop-down list in the Flash Memory area.
If you want the file to be written at an offset in the Flash memory, specify the offset using the Program at Offset field.
Specify any memory that will be used by the Flash programmer as a scratch memory using the Instance Name drop-down list in the Scratch Memory area.
Note: The current contents of this memory will be overwritten.
If you want to create a bootloader for the executable program in the Flash memory, click to select the Create Flash Bootloader Application check box. Specify the software platform to use and software application project name for the bootloader application.
Click OK.
SDK programs the Flash with the file. If you opted to create a bootloader application, a software application project is created in the workspace with the source and header files.

Programming parallel Flash

Configuring the JTAG settings
Configuring the FPGA

Flash Memory Programmer dialog box