General Description:
When I try to run either Trace or SPEEDPRINT with a voltage specification, the following messages are reported:
- "Requested a Voltage of <> Volts"
- "Requested voltage (<>) outside supported range (1.60 to 2.00)"
This happens even if the default voltage of 1.5 is specified.
Voltage prorating is not yet supported for Virtex-II. Users should not specify any voltage; the given values will correspond to the default core voltage of 1.5V.
AR# 11131 | |
---|---|
Date | 01/18/2010 |
Status | Archive |
Type | General Article |