General Description: In FPGA Editor 4.1i, the router hangs when I try to autoroute a net. I choose two slices, add them to the component list, then choose a pin on each slice. I then press the route button, a new net is made, and a straight line comes between them. I then press the "Autoroute" button to do the final route between them and it hangs.
Solution
This will be fixed in the next major software release after 4.1i.
Was this Answer Record helpful?
AR# 12146
Date
10/08/2003
Status
Archive
Type
General Article
By using this website, I accept the use of cookies.
Learn more