Page Bookmarked

AR# 12216

14.x Timing Analyzer - The Custom Analysis data sheet section does not include the Clock-to-Setup table

Why does the data sheet section not include the Clock-to-Setup table when I perform a Custom Analysis?

The Clock-to-Setup table does not appear because the clock path does not go through the net that was selected for inclusion.

If you include the clock net in the selected nets, the Clock-to-Setup table will appear correctly.

Was this Answer Record helpful?

AR# 12216
Date	12/15/2012
Status	Active
Type	General Article
Tools	ISE - 10.1 ISE Design Suite - 11.1 ISE Design Suite - 11.2 More ISE Design Suite - 11.3 ISE Design Suite - 11.4 ISE Design Suite - 11.5 ISE Design Suite - 12.1 ISE Design Suite - 12.2 ISE Design Suite - 12.3 ISE Design Suite - 12.4 ISE Design Suite - 13 ISE Design Suite - 13.1 ISE - 8.1i ISE - 8.1i sp1 ISE - 8.1i sp2 ISE - 8.1i sp3 ISE - 8.2i ISE - 8.2i sp1 ISE - 8.2i sp2 ISE - 8.2i sp3 ISE - 9.1i ISE - 9.1i sp1 ISE - 9.1i sp2 ISE - 9.1i sp3 ISE - 9.2i ISE - 9.2i sp1 ISE - 9.2i sp2 ISE - 9.2i sp3 ISE - 9.2i sp4 ISE - Legacy ISE Design Suite - 13.2 ISE Design Suite - 13.3 ISE Design Suite - 13.4 ISE Design Suite - 14.1 Less