AR# 1388: XABEL/FOUNDATION: What is needed to compile a design containing XABEL blocks
AR# 1388
XABEL/FOUNDATION: What is needed to compile a design containing XABEL blocks
Description
To be able to compile a design containing XABEL blocks in Foundation, you will need to install the following:
For FPGA and/or XC7000 designs: 1. The Foundation package (schematic entry, HDL Editor, and simulation) 2. XABEL (DS371). This may be installed from either the Foundation CDROM or from the XACTStep CDROM. 3. XACTStep 6
For XC9500 designs: 1. The Foundation package V6.0.1 (schematic entry, HDL Editor, and simulation) 2. XABEL (DS371). This may be installed from either the Foundation CDROM or from the XACTStep CDROM. 3. XACT-CPLD (DS560)
This will allow you to enter and synthesize the ABEL design, implement the design, and also do a timing simulation in Foundation after the design has been implemented.
Solution
Was this Answer Record helpful?
AR# 1388
Date
03/08/2000
Status
Archive
Type
General Article
By using this website, I accept the use of cookies.
Learn more