We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 14542

4.1i CPLD CoolRunner XPLA3 - Pull-ups are not configured for input registers


Keywords: 4.1i, 4.2i, CPLD, CoolRunner, XPLA3, pull-up, pullup, input register

Urgency: Low

General Description:
An input pin is set to use a pull-up; however, this pin is not pulled up on the device.


This issue only affects pins that are configured as input registers.

This problem was fixed in 4.2i Service Pack 3, available at:
AR# 14542
Date 08/06/2003
Status Archive
Type General Article
Page Bookmarked