AR# 1843

QuickSim: Mode pins (MDO, MD1, MD2) cannot be used in board-level simulation.

Description

Keywords: mode pins, MD0, MD1, MD2, board-level, pads

Urgency: Standard

General Description:

A board level simulation of a design that contains mode pins (MD0, MD1,
MD2) will not accept any force to the nets connected to these pins. The
waveform will only show strong contention on the signals.

Solution

The only workaround is to remove the mode pins from the design and replace
them with standard I/O pads.
AR# 1843
Date 10/01/2008
Status Archive
Type General Article