UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 20932

7.1i ISE Incremental Design Flow - "An error occured while executing %XILINX%/data/projnav/scripts/TclFileWrapper4Halite.tcl..."

Description

Keywords: Project Navigator, failed, run, dpm_maprun, MAP, PAR, Guide Mode, nc1TOncd_tcl

In a design that previously implemented successfully, when I select the Enable Incremental Design Flow property in the Incremental Design Properties tab, the following error occurs:

"An error occurred while executing C:\Xilinx/data/projnav/scripts/TclFileWrapper4Halite.tcl
Process TclFileWrapper4Halite.tclk dpm_mapRun __projnav/sumrpt_tcl.rsp failed with code:00199"

The error occurs immediately after the MAP phase appears to be finished. However, the MAP process is marked with a red X.

If I continue with the Place and Route process (since map.ncd is successfully generated), the following error message occurs after pad generation and before the static timing analyzer is run:

"Process 'TclFileWrapper4Halite.tcl dpm_parRun __projnav/nc1TOncd_tcl.rsp __projnav/sumrpt_tcl.rsp' failed with code:00199."

Solution

Install the latest Service Pack to use Incremental Design in 7.1i.

This problem has been fixed in the latest 7.1i Service Pack available at:
http://www.xilinx.com/xlnx/xil_sw_updates_home.jsp
The first service pack containing the fix is 7.1i Service Pack 1.
AR# 20932
Date Created 03/08/2005
Last Updated 12/13/2006
Status Archive
Type General Article