When I attempt to connect from XMD to a MicroBlaze or PowerPC Processor, Windows error reports:
"The instruction at "0x0040d7a4" referenced memory at "0x65726178". The memory could not be "read". Click on OK to terminate the program".
If I launch XMD from a Cygwin Shell, the following error message appears:
"ERROR:Portability:3 -...As it is likely that this may be an unforeseen problem, please be prepared to submit relevant design files if necessary."
This problem occurs if EDK 7.1 Service Pack 2 is installed without EDK 7.1 Service Pack 1 having been installed.
To resolve the problem:
- Uninstall EDK 7.1 Service Pack 2
- Install EDK 7.1 Service Pack 1
- Install EDK 7.1 Service Pack 2