UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 2335

Hardware Debugger M1.3: Cable Self Check fails or doesn't run specified number of cycles.

Description

Keywords: debug, cable, self, check, cycle

Urgency: Standard

General Description:

Cable Self Check does not seem to be working correctly. The specified
"number of cycles" is set for 6, no matter what test is selected, a
new dialog comes up which shows "number of cycles=1",
passes=0,fails=1,yield=0.0. This usually means that the Test Header
was not connected to the cable or power (VCC/GND) were not connected
to the Test Header.

Solution

Insert the Test Header into the xchecker pod, and connect VCC and GND
to the connectors "red" and "black" respectively.
AR# 2335
Date Created 06/07/1997
Last Updated 11/10/2004
Status Archive
Type General Article