UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!
  1. Xilinx - Adaptable. Intelligent.
  2. Support
  3. AR# 24815: MPMC2 GUI v1.7 - Memory Configuration requires more chip selects than what the GUI generates

AR# 24815

MPMC2 GUI v1.7 - Memory Configuration requires more chip selects than what the GUI generates

Description

The system only has enough chip selects for 1 DIMM (or component) and the MPMC2 IP Configurator (GUI) is not adding the signals for the second DIMM. How do I add in the necessary signals if the GUI will not?

Solution


This is a known issue with MPMC2 IP Configurator and is not indicated in the Release Notes.



To work around this problem, do the following:



1. Make a backup copy of the MHS file.

2. Open the MHS file for editing.

3. Find the MPMC2 instance.

4. Add or modify the C_MPMC2_0_MEM_CS_N_WIDTH to the number of chip selects desired. You should ensure that the parameter is not already defined, since a duplicate parameter entry will cause the XPS tool to generate an error.



Depending on the board, you might also need to change or add the following:



* C_MPMC2_0_MEM_CLK_WIDTH

* C_MPMC2_0_MEM_CE_WIDTH

* C_MPMC2_0_MEM_ODT_WIDTH



Again, you should ensure that the parameter is not already defined, since a duplicate parameter entry will cause the XPS tool to generate an error.



These parameters all have the same prefix as the C_MPMC2_0_MEM_CS_N_WIDTH. Avoid overwriting any of the other width parameters in the MHS file, as you might end up with unexpected results.
AR# 24815
Date 11/12/2010
Status Archive
Type General Article

By using this website, I accept the use of cookies.   Learn more

Page Bookmarked