We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 32400

10.1 CORE Generator - Running Batch mode, the XCO file is not updated after parameters changed in regeneration


This problem will generally only occur when a user is manually editing the content of the XCO file in a text editor.

The IP CORE netlist is correctly generated as indicated in the warning message. However, the XCO file does not reflect the generated value. If you see this message, the XCO file should be opened in the customization GUI before regenerating. Using this procedure, the user is also able to verify that all parameters are set as desired.

This issue is resolved in ISE 11.1.
AR# 32400
Date 07/29/2010
Status Archive
Type General Article
Page Bookmarked