AR# 32608

10.1 EDK - How to set the sensitivity of the interrupt?

Description

Keywords: sensitivity, interrupt, set, edge, level

When I create a Base System Builder design in EDK, the interrupt of the processor is set to "LEVEL_HIGH", whereas the Interrupt of the
peripheral is set to "EDGE_RISING". How can I set the sensitivity of the interrupt?

Solution

This can be done by making the interrupt signal of either the processor or the peripheral external.
After doing this, we have an option of configuring the interrupt as per our requirement.


AR# 32608
Date 05/14/2009
Status Active
Type General Article