We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 33801

11.4 PlanAhead - Can I change the width of my I/O Buses in Initial Pin Planning mode?


I am doing initial pin planning on a set of ports that I have imported from either csv or ucf. I would like to change the width of some buses defined in those input files after they have been imported into PlanAhead. Is this possible?


At this time, it is not possible to change the width within PlanAhead. This functionality will be added in a future PlanAhead release.

AR# 33801
Date 05/23/2014
Status Archive
Type General Article
Page Bookmarked