"> AR# 34413: MIG Virtex-6 DDR2/DDR3 - Supported Memory Devices

UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 34413

MIG Virtex-6 DDR2/DDR3 - Supported Memory Devices

Description

This section of the MIG Design Assistant focuses on the supported memory devices for Virtex-6 DDR3/DDR2 designs. For information related to your specific question, see the Solution section.

NOTE: This answer record is part of the Xilinx MIG Solution Center (Xilinx Answer 34243). The Xilinx MIG Solution Center is available to address all questions related to MIG. Whether you are starting a new design with MIG or troubleshooting a problem, use the MIG Solution Center to guide you to the right information.

Solution

The MIG GUI allows you to specify a number of pre-configured memory controllers for specific memory devices.From the GUI, you specify the memory type: Component, SODIMM, UDIMM or RDIMM and the specific memory part. If the specific memory device you are using is not listed, you can select "Create Custom Part" to manually target many devices.When a custom part is used, you must identify a "base part" that matches your memory device's data width and memory depth. The "Create Custom Part" GUI requires that you enter a number of timing parameters that are available in the device data sheet. The supported range is shown in the GUI.

For further details on specifying your memory device in the GUI, see "Creating Virtex-6 FPGA DDR3 Memory Controller Block Design" in the Virtex-6 FPGA Memory Interface Solutions User Guide (UG406): http://www.xilinx.com/support/documentation/ip_documentation/ug406.pdf.

For a list of supported memory devices, see "Supported Devices for Virtex-6 FPGAs" in the Virtex-6 FPGA Memory Interface Solutions User Guide (UG406): http://www.xilinx.com/support/documentation/ip_documentation/ug406.pdf.

For details on the SCL/SDA pins specific to RDIMM memory devices, see (Xilinx Answer 34414).

Additional Information

(Xilinx Answer 41089) MIG Virtex-6 DDR3 - Can twin die DDR3 component be supported by Virtex-6?

Linked Answer Records

Master Answer Records

Answer Number Answer Title Version Found Version Resolved
34314 MIG 7 Series and Virtex-6 DDR2/DDR3 - Supported Devices N/A N/A

Associated Answer Records

Answer Number Answer Title Version Found Version Resolved
41089 MIG Virtex-6 DDR3 - Can TwinDie DDR3 components be supported on Virtex-6? N/A N/A
34314 MIG 7 Series and Virtex-6 DDR2/DDR3 - Supported Devices N/A N/A
AR# 34413
Date Created 05/19/2010
Last Updated 02/27/2013
Status Active
Type Solution Center
Devices
  • Virtex-6 CXT
  • Virtex-6 LX
  • Virtex-6 LXT
  • Virtex-6 SXT
IP
  • MIG