AR# 37833


iMPACT, CoolRunner II - Why is it no longer possible to select "on the fly" (otf) program?


In previous version of iMPACT (up to ISE software 8.1) it was possible to select on the fly when programming a CoolRunner II device; now this is not possible. Why?


This is a known issue, the on the fly option is no longer in the GUI, but is still supported in batch mode by using the -oft switch when programming the device.

If using the GUI is required, then an older version of iMPACT can be used.
AR# 37833
Date 09/10/2010
Status Active
Type General Article
People Also Viewed