UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 37929

12.x ChipScope - MAP reports "ERROR:LIT:292" after inserting ChipScope cores in the design

Description

After adding ChipScope analyzer cores in the design, MAP reports the following error.

ERROR:LIT:292 - The same signal is driving pin D of ISERDES symbol
"xxxxxx", pin D of FLOP symbol "xxxxxx"
(output signal=xxxxxx). A signal driving the D pin of an
ISERDES can not drive any other load.

What is the problem? How can I resolve the problem?

Solution

This error occurs because the net from the IBUF to D pin of ISERDES is connected to the ChipScope analyzer cores. But, this net cannot be routed to any load other than the D pin of the ISERDES.

If you want to observe the signal connected to the D pin of ISERDES, a workaround is to use the O pin. THe O pin of ISERDES is the combinational output from the D pin through the ISERDES component. You can connect the O pin to the ChipScope cores instead.

For more information of O pin of ISERDES, please refer to the Libraries Guide of the device.
AR# 37929
Date Created 12/21/2010
Last Updated 12/15/2012
Status Active
Type General Article
Tools
  • ChipScope Pro - 11.3
  • ChipScope Pro - 11.4
  • ChipScope Pro - 11.5
  • More
  • ChipScope Pro - 11.1
  • ChipScope Pro - 11.2
  • ChipScope Pro - 12.1
  • ChipScope Pro - 12.2
  • ChipScope Pro - 12.3
  • Less