UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 43630

MIG Spartan-6 MCB - PHY Calibration Steps

Description

This section of the MIG Design Assistant focuses on the PHY Calibration Steps for Spartan-6MCB designs.

Note: This Answer Record is a part of the Xilinx MIG Solution Center (Xilinx Answer 34243).The Xilinx MIG Solution Center is available to address all questions related to MIG. Whether you are starting a new design with MIG or troubleshooting a problem, use the MIG Solution Center to guide you to the right information.

Solution

The following diagram shows the Spartan-6 MCB sequence for initialization and calibration:

When calibration completes successfully, calib_done asserts. For detailed information on each stage, see the following:

Linked Answer Records

Associated Answer Records

Answer Number Answer Title Version Found Version Resolved
43665 MIG Spartan-6 MCB - MCB Hard Calibration N/A N/A
43662 MIG Spartan-6 MCB - Soft Calibration N/A N/A
40683 MIG Spartan-6 MCB - PHY Architecture N/A N/A
43663 MIG Spartan-6 MCB - Clock Requirements N/A N/A
AR# 43630
Date Created 08/25/2011
Last Updated 12/15/2012
Status Active
Type General Article
Devices
  • Spartan-6 LX
  • Spartan-6 LXT
IP
  • MIG