AR# 45278
LogiCORE IP DisplayPort v2.3 - Why do I get an error in MAP for the Hot Plug Detect (HPD) pin, when trying to target Kintex-7 FPGA?
Description
Why do I receive an error in MAP for the Hot Plug Detect (HPD) pin, when trying to target a Kintex-7 FPGA?
ERROR:Pack:2503 - The "IOB33" component is not supported in this particular device.
Solution
This is because the output standard used for HPD is not supported for all Kintex-7 devices.
This will be fixed in the LogiCORE DisplayPort v3.1.
To work around this issue, make the following changes:
UCF:NET "hpd" IOSTANDARD = "LVCMOS18";
dport_rx_phy.v,
//----------------------------------------------
// Hot Plug Detect
//----------------------------------------------
OBUF_LVCMOS18 hot_plug_detect_inst (
.O (hpd),
.I (hot_plug_detect)
)
Please see (Xilinx Answer 33258) for a detailed list of LogiCORE IP DisplayPort Release Notes and Known Issues.
Was this Answer Record helpful?
Linked Answer Records
Master Answer Records
| Answer Number | Answer Title | Version Found | Version Resolved |
|---|---|---|---|
| 33258 | LogiCORE IP DisplayPort - Release Notes and Known Issues | N/A | N/A |
| AR# 45278 | |
|---|---|
| Date | 08/11/2014 |
| Status | Active |
| Type | General Article |
| Devices |
|
| IP |
|