AR# 4700


Foundation F1.5: SC caused a GPF in module SC_LIBR.DLL when saving symbol


General Description:

When using the Foundation Symbol Editor in F1.5 to modify the pins on a symbol,

the following error may occur:

SC caused a GPF in module SC_LIBR.DLL at <hex address>.

The symbol has been saved correctly but the General Protection Fault causes

Foundation to close. The GPF does not occur each time the Symbol Editor is


This has also been seen when updating an HDL macro from the HDL Editor, when

the editor has been opened via the schematic.


This problem has been resolved in Foundation F1.5i. Please upgrade to this

new release when possible.
AR# 4700
Date 03/07/2012
Status Archive
Type General Article
People Also Viewed