AR# 50514


Route - Process "Place & Route" failed at Phase 6 of the router


An ISE design is receiving the following crash with no error message in the Router.

Phase  6  : 0 unrouted; (Setup:4712, Hold:1838, Component Switching Limit:0)     REAL time: 3 mins 1 secs
Process "Place & Route" failed


In this case, it was found that some RLOC constraints in the UCF were the cause of the issue.

Removing the lines from the UCF allowed the tools to complete. 

This problem has been resolved in ISE 14.3.

AR# 50514
Date 07/31/2014
Status Active
Type General Article
People Also Viewed